Jog Recovery
The software involved in jogging the 2MASS instrument is finicky and convoluted. This is due to the complexities in communicating with older hardware and software. If the jog function is not working, go through the steps below:
Power off camera in astrocam
Close Astrocam
Close DS9
Close XEIF
Cycle power on the Telcom Network Translator by pressing the red button and releasing
Open a terminal window on big2mass. Ping the network translator at 10.13.3.2 to verify its online
Start XEIF, Astrocam, DS9 in that order
If jog still does not work:
Follow steps 1-4 above
Send telescope to stow
Switch the TDC from computer to manual
Turn off the RA and Dec Motor Power
Exit the FORTH program
Cycle power to the FORTH computer
Begin startup procedure for telescope
Cycle power on the Telcom Network Translator by pressing the red button and releasing
Open a terminal window on big2mass. Ping the network translator at 10.13.3.2 to verify its online
Start XEIF, Astrocam, DS9 in that order
If Jog still does not work: Call Scott at (520) 499-4860 or Joe at (520) 820-3117