MOON

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Starting NESLAB ======

^ ^Jun 14, 2021, P Gabor et al.^ ✔✘ ^ 
|Silo 2nd lvl|NESLAB: First night of the run check coolant level; not necessary on following nights, unless there is a visible leak. [Access hatch is on the top of the cabinet, at the far left. Under the hatch is the hatch into the coolant reservoir, removable with two captured thumbscrews. Coolant should cover the visible, coiled pipes. DO NOT ADD COOLANT WITHOUT CONSULTING THE DAY CREW (Gary Gray): it is better to run with the coolant slightly low (i.e., ~1/4 of the diameter of the top, coiled pipe exposed) than to put the wrong coolant mixture into the reservoir.]| |
|Silo 2nd lvl|**Turn NESLAB on only if VATTtel is already booted so that you can turn cell fans and thermal control on without undue delay**| |
|Silo 2nd lvl|NESLAB: Simultaneously toggle front panel ON/OFF switch to "ON" & slowly raise manual valve lever (to minimize vibration)| |
|Silo 2nd lvl|NESLAB: Also simultaneously: watch pneumatic-actuated valves "OPEN"| |
|Silo 2nd lvl|NESLAB: Check pressure gauge (usually well above the nominal 56 psi)| |

MOON

User Tools

Site Tools

Page Tools