vatt:liquid_nitrogen_for_itl_cameras
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
vatt:liquid_nitrogen_for_itl_cameras [2024/06/11 14:29] paul |
vatt:liquid_nitrogen_for_itl_cameras [2024/06/11 14:38] (current) paul |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | *start filling | + | *make sure the ground wire is connected: |
| - | *fill out LN2/camera log – listen for full dewar, cease flow when dewar is full | + | * first to the mirror cell and |
| + | * then to the camera | ||
| + | *insert the nozzle into the dewar, and attach it using the bungee cord | ||
| + | *opening the valve, | ||
| + | *fill out LN2/camera log – listen for full dewar | ||
| + | *cease flow when dewar is full | ||
| *disconnect LN2 filler hose from camera dewar, move storage dewar off of telescope platform and south, to dome silo wall) | *disconnect LN2 filler hose from camera dewar, move storage dewar off of telescope platform and south, to dome silo wall) | ||
| *remove camera ground wire and clip it on silo, near storage dewar | *remove camera ground wire and clip it on silo, near storage dewar | ||
vatt/liquid_nitrogen_for_itl_cameras.1718141375.txt.gz · Last modified: 2024/06/11 14:29 by paul
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
