This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
recharging_the_ccd_desiccant [2019/07/30 09:55] davner removed |
— (current) | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Recharging the CCD Desiccant ====== | ||
| - | Amateur CCD cameras generally use a desiccant to absorb moisture that would otherwise condense on the CCD window or chip. When the chip is cooled any latent moisture crystallizes and forms ice. See the picture below: | ||
| - | |||
| - | {{: | ||
| - | |||
| - | The above clearly shows frost. However, ice usually forms a translucent (foggy) circle that changes size while the chip is cooled (and then is " | ||
| - | |||
| - | ===== Procedure ===== | ||
| - | |||
| - | - In a clean space, using electrostatic precautions, | ||
| - | - Remove the four bolts that surround the CCD window and attach the bottom of the filter wheel enclosure to the front face of the CCD camera body. | ||
| - | - {{: | ||
| - | - Now remove the 8 bolts around the middle of the camera body in order to access the internal parts. | ||
| - | - {{: | ||
| - | - Carefully lift the upper portion without unplugging or tugging on the wires that connect to the shutter. | ||
| - | -{{: | ||
| - | - The black knurled plug contains the desiccant. Carefully unscrew it from the CCD chamber. | ||
| - | -{{: | ||
| - | - Cover the hole to the CCD chamber with a piece of electrical tape while drying the desiccant. | ||
| - | -{{: | ||
| - | - **IMPORTANT!** Carefully examine the plug and remove the rubber O-Ring. | ||
| - | -{{: | ||
| - | -{{: | ||
| - | - Bake plug (without O-ring) in an oven heated to 350F degrees for 4 hours. After baking and once it is cool to the touch, reinstall the plug and reassemble the CCD camera. | ||