This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
recharging_the_ccd_desiccant [2017/03/23 21:07] adam |
— (current) | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Recharging the CCD Desiccant ====== | ||
- | Amateur CCD cameras generally use a desiccant to absorb moisture that would condense on the CCD window or chip. When the chip is cooled any latent moisture crystallizes and forms ice. See the picture below: | ||
- | |||
- | {{: | ||
- | |||
- | The above clearly shows frost. However, ice usually forms a translucent (foggy) circle that changes size while the chip is cooled (and then is " | ||
- | |||
- | ===== Procedure ===== | ||
- | |||
- | - In a clean space, using electrostatic precautions, | ||
- | - Remove the four bolts that surround the CCD window and attach the bottom of the filter wheel enclosure to the front face of the CCD camera body. | ||
- | - {{: | ||
- | - Now remove the 8 bolts around the middle of the camera body in order to access the internal parts. | ||
- | - {{: | ||
- | - Carefully lift the upper portion without unplugging or tugging on the wires that connect to the shutter. | ||
- | -{{: | ||
- | - The black knurled plug contains the desiccant. Carefully unscrew it from the CCD chamber. | ||
- | -{{: | ||
- | - Cover the hole to the CCD chamber with a piece of electrical tape while drying the desiccant. | ||
- | -{{: | ||
- | - **IMPORTANT!** Carefully examine the plug and remove the rubber O-Ring. | ||
- | -{{: | ||
- | -{{: | ||
- | - Bake plug (without O-ring) in an oven heated to 350F degrees for 4 hours. After baking and once it is cool to the touch, reinstall the plug and reassemble the CCD camera. |