public:lemmon:minnesota_60:cold_start_power_up_sequence
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
public:lemmon:minnesota_60:cold_start_power_up_sequence [2019/04/22 16:55] davner |
public:lemmon:minnesota_60:cold_start_power_up_sequence [2019/05/09 11:10] (current) davner ↷ Page moved from public:minnesota_60:cold_start_power_up_sequence to public:lemmon:minnesota_60:cold_start_power_up_sequence |
||
|---|---|---|---|
| Line 4: | Line 4: | ||
| //Procedure for coming out of lightning shutdown or checking out the telescope and instrument.// | //Procedure for coming out of lightning shutdown or checking out the telescope and instrument.// | ||
| ---- | ---- | ||
| - | =====Dome===== | + | =====Dome |
| - Dome encoder cable over entry door | - Dome encoder cable over entry door | ||
| ===West side of blue yoke, declination axis=== | ===West side of blue yoke, declination axis=== | ||
| - | - dec encoder | + | - Dec encoder |
| - | - dec motor | + | - Dec motor |
| - | - dec tac | + | - Dec tac |
| ===West side of base flange=== | ===West side of base flange=== | ||
| - Finder scope lamp power (for reticle) | - Finder scope lamp power (for reticle) | ||
| Line 92: | Line 92: | ||
| ===Front of rack #1=== | ===Front of rack #1=== | ||
| - Microphone connection for dome | - Microphone connection for dome | ||
| - | ===Behind control console | + | ===Behind control console=== |
| - Plug two calbes running into ceiling | - Plug two calbes running into ceiling | ||
| - Plug power strip and UPS laying on the floor into the wall outlet | - Plug power strip and UPS laying on the floor into the wall outlet | ||
| - Plug two ethernets | - Plug two ethernets | ||
| - | =====Dome Part 3===== | + | |
| + | ---- | ||
| + | =====Dome Part 2===== | ||
| ===2MASS=== | ===2MASS=== | ||
| - Plug in UPS into wall outlet. | - Plug in UPS into wall outlet. | ||
| Line 109: | Line 111: | ||
| - Turn on Controller power supply | - Turn on Controller power supply | ||
| - Turn on IR Camera power supply | - Turn on IR Camera power supply | ||
| + | |||
| + | ---- | ||
| + | ===Follow the instructions in the black binder to finish setup.=== | ||
public/lemmon/minnesota_60/cold_start_power_up_sequence.1555977309.txt.gz · Last modified: 2019/04/22 16:55 by davner
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
