public:catalinas:lemmon:schulman_32:desktop_icons_and_software_layout
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
public:catalinas:lemmon:schulman_32:desktop_icons_and_software_layout [2022/09/23 12:04] tdeyoe [ASIStudio] |
public:catalinas:lemmon:schulman_32:desktop_icons_and_software_layout [2023/08/24 12:02] (current) tdeyoe [TheSkyX] |
||
|---|---|---|---|
| Line 9: | Line 9: | ||
| ==== Maestro3 ==== | ==== Maestro3 ==== | ||
| + | Controls the telescope. This is the direct communication with the TCS (Telescope Control System) and must be open to operate it. All other softwares that can control the telescope do so through the ASCOM driver Maestro3 provides. | ||
| + | Eventually will be replaced by Maestro4. | ||
| ==== ACP ==== | ==== ACP ==== | ||
| Line 15: | Line 17: | ||
| ==== TheSkyX ==== | ==== TheSkyX ==== | ||
| + | {{: | ||
| ==== ASCOM Dome Control ==== | ==== ASCOM Dome Control ==== | ||
| If you want to operate just the dome (I.E. open, close, park, home, point to specific Azimuth, etc) this is a single interface to do all of that. | If you want to operate just the dome (I.E. open, close, park, home, point to specific Azimuth, etc) this is a single interface to do all of that. | ||
| Line 21: | Line 23: | ||
| **NOTE: If this is connected to the dome no other software will be able to access the dome.** | **NOTE: If this is connected to the dome no other software will be able to access the dome.** | ||
| ==== FocusPro ==== | ==== FocusPro ==== | ||
| + | Currently operates the focuser. pretty small and simply interface. Will eventually be merged with Maestro4. | ||
| ==== FocusMax V5 ==== | ==== FocusMax V5 ==== | ||
| FocusMax handles autofocusing routines. It's set up to connect to MaxIm DL for the camera, FocusPro for the focuser, and ACP for the telescope. Used for automated focus routines within ACP and ACP scheduler. | FocusMax handles autofocusing routines. It's set up to connect to MaxIm DL for the camera, FocusPro for the focuser, and ACP for the telescope. Used for automated focus routines within ACP and ACP scheduler. | ||
public/catalinas/lemmon/schulman_32/desktop_icons_and_software_layout.1663959883.txt.gz · Last modified: 2022/09/23 12:04 by tdeyoe
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
