public:catalinas:lemmon:minnesota_60:cold_start_power_up_sequence
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
public:catalinas:lemmon:minnesota_60:cold_start_power_up_sequence [2019/06/13 13:42] davner |
public:catalinas:lemmon:minnesota_60:cold_start_power_up_sequence [2019/06/21 15:21] (current) davner |
||
|---|---|---|---|
| Line 54: | Line 54: | ||
| - #1 single paddle control to old paddle | - #1 single paddle control to old paddle | ||
| - FORTH computer backside | - FORTH computer backside | ||
| - | - //NOTE: If 2MASS is on the telescope there is nothing to disconnect. If another instrument is on the telescope then disconnect Com2 cable.// | + | - //NOTE: If 2MASS is on the telescope there should be nothing to connect.// |
| - Silver outlet box | - Silver outlet box | ||
| - Bus BNC | - Bus BNC | ||
| Line 93: | Line 93: | ||
| - Microphone connection for dome | - Microphone connection for dome | ||
| ===Behind control console=== | ===Behind control console=== | ||
| - | - Plug two calbes | + | - Plug two cables |
| - Plug power strip and UPS laying on the floor into the wall outlet | - Plug power strip and UPS laying on the floor into the wall outlet | ||
| - Plug two ethernets | - Plug two ethernets | ||
| Line 113: | Line 113: | ||
| ---- | ---- | ||
| - | ===Follow the instructions in the black binder to finish setup.=== | + | ===Follow the instructions in the UMINN 60"/ |
public/catalinas/lemmon/minnesota_60/cold_start_power_up_sequence.1560458520.txt.gz · Last modified: 2019/06/13 13:42 by davner
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
