phd2:phd2_guiding
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
phd2:phd2_guiding [2018/10/04 15:35] cjohnson |
phd2:phd2_guiding [2019/04/25 20:56] scott |
||
|---|---|---|---|
| Line 19: | Line 19: | ||
| * ('' | * ('' | ||
| - in '' | - in '' | ||
| + | * equipment profile "vatt imagers" | ||
| * camera type "INDI Camera", | * camera type "INDI Camera", | ||
| * mount type "INDI Mount", | * mount type "INDI Mount", | ||
| Line 36: | Line 37: | ||
| * in the network section: | * in the network section: | ||
| * subnet: 10.0.255.255 | * subnet: 10.0.255.255 | ||
| - | * ip:port : 10.0.3.14: | + | * **Note the 4K guider is being repaired currently. We are using the VATTspec guider for all guiding. In practice this means the ip:port will be 10.0.3.12: |
| + | * < | ||
| - click the '' | - click the '' | ||
| - | * (after a few seconds, a bunch of new fields and tabs should appear.) | + | * (after a few seconds, a bunch of new fields and tabs should appear) |
| + | * (The message " | ||
| - near the bottom of the window, turn on the cooler | - near the bottom of the window, turn on the cooler | ||
| - IF YOU ARE GOING TO BE AUTOGUIDING: | - IF YOU ARE GOING TO BE AUTOGUIDING: | ||
| Line 46: | Line 50: | ||
| - exit the '' | - exit the '' | ||
| - click OK in the '' | - click OK in the '' | ||
| - | - in '' | ||
| - | * ('' | ||
| - click '' | - click '' | ||
| * (the button should now say '' | * (the button should now say '' | ||
| Line 77: | Line 79: | ||
| * The Dark Library is located in the directory ''/ | * The Dark Library is located in the directory ''/ | ||
| * The directory ''/ | * The directory ''/ | ||
| - | * If you need to capture more than 100 images, make a renamed copy of the session directory; new // | + | * If you need to capture more than 100 images, make a renamed copy of the session directory; new // |
| * Start Imaging | * Start Imaging | ||
| - in the bottom left of the PHD2 window there is a button with 2 arrows forming a circle. Click that button. | - in the bottom left of the PHD2 window there is a button with 2 arrows forming a circle. Click that button. | ||
| - the button should gray out, the stop sign button should turn red, and images should start appearing | - the button should gray out, the stop sign button should turn red, and images should start appearing | ||
| + | * Start Guiding | ||
| + | - change the exposure time setting and contrast slider to find an appropriate guide star. | ||
| + | - Click on the guide star | ||
| + | - click on the circular icon i the tool bar that looks like a target | ||
| + | |||
| + | |||
| + | Offset Guider Stage | ||
| + | |||
| + | Note: All numbers are GUI units. The travel limits are accurate but the diagram is only an approximation. | ||
| + | {{ : | ||
| + | |||
phd2/phd2_guiding.txt · Last modified: 2019/04/25 20:59 by scott
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
